3h
17m
15.2w
40fps
OLED
Configuration
Graphics preset
medium
Screen refresh rate
80fps
Framerate limit
none
Average framerate
40fps
Tdp limit
none
resolution
1280
x
800
System
Proton version
9.0-3
Steamos version
3.6
Note
For this game, I have installed the FrameGen mod via Decky FrameGen Plugin, but I will not be using the FrameGen feature. I did this so that I can replace DLSS with FSR 3 and basically upgrade to a better FSR experience. You don't have to do this, but it will result in better image quality.
For the in-game settings, adjust as follows:
Note: I use CryoUtilities 2.0 @ recommended settings, have my UMA Frame Buffer Size set to 4 GB, and undervolt with -30 mV for all offsets. This broadly improves performance and stability, and it can sometimes even allow for pushing higher graphics settings.
For this game, I have installed the FrameGen mod via Decky FrameGen Plugin, but I will not be using the FrameGen feature. I did this so that I can replace DLSS with FSR 3 and basically upgrade to a better FSR experience. You don't have to do this, but it will result in better image quality.
For the in-game settings, adjust as follows:
- V-Sync: OFF
- Nvidia Reflex Low Latency: ON (if using the FrameGen mod)
- DLSS Frame Generation: OFF (can enable for higher FPS at the cost of input lag)
- Adaptive Supersampling Tech: Nvidia DLSS (is using the FrameGen mod; if not, go with FSR)
- Adaptive Supersampling Quality: Quality
- Level of Detail, Texture Quality, SSAO, Mirror Reflection Quality, and Reflection Quality: Medium
- Texture Filter: Antistropic 8X
- Shadow Quality: Low
If you opt to actually use Frame Generation (not needed, imo), enable V-Sync and disable frame limit in GameScope to improve input latency. Set the refresh rate to your target FPS.
Otherwise, in GameScope, cap the Frame Limit at 40FPS/80Hz.
Otherwise, in GameScope, cap the Frame Limit at 40FPS/80Hz.
ADHDefy
Playtime:
-
/
-
